30J-F6 CA Flammable (Catalytic 2v / 170mA) 1 - 64 Input Addressable

The 30J enclosure has been designed to allow quick and easy access to its interior by adjustment of two allen screws, this factor is a major consideration when large system service and calibrations are being carried out. The detector is robust and weather-proof with improved response times due to the four mounting spacers allowing increased air movement around the detector these spacers also improve the mounting of the unit particularly on circular pillars typically found in car parks. Standard 4~20mA signalling with CAN bus address enables the sensors to be networked via the GDS Combi control system or customer preferred monitoring system

Specifications

Power Supply - 15 to 30vDC 24v nominal
Outputs
3 wire - 4~20mA
4 wire - CAN bus
Relays (optional)
Low alarm S .P.C.O
High alarm S .P.C.O
Fault alarm S .P.C.O / over range
Rating 0.5A @30vDC
Inhibit option during servicing
Logging
Addressable sensors only
Intervals - one minute to one hour
Storage - 2,880 readings
Temperature:-15⁰C to 55⁰C
Humidity:0⁰C to 99% RH - non condensing

DETECTOR HEAD
Type - F6 Hazardous area use
Data Sheet - Ref C994
Certification - ATEX / IECEX
Ingress Protection - IP63, + Universal fitting IP64
Material - Stainless Steel 316 S16
Weight - 35gms
Sensor Type - Pellistor-catalytic: flammable 0 - 100% LEL - 170mA
Accessories - Optional
Collector Cone + Universal Fitting
Universal Fitting (test gas applicator/spray deflector)
Flow Block
Detector Head Weather Shield

JUNCTION BOX
Type - 30J Safe area use only
Deep box (D) S hallow B ox (S)
Ingress Protection - IP64
Material - ABS Flame retardant FR 40 / Lid Screws M4SS
Finish - Signal White RAL 9003
Weight - 380gms
Entries - Rear 5-20mm knockouts / Sides, Top, Bottom - not specified
Mounting
Standoffs - M4 or N o 8 screws
Drill at (C) when standoffs removed
Conduit box - drill at (A) 4.5mm
Surface mount box - drill at (B) 4.5mm
EU Design No. - 01359723-0001